CRM Mitchell1, Author at JR Automotive

2013 Nissan Sentra
Mileage
192,672
Service Date
11/10/2023
Services Performed
MASS AIR FLOW SENSOR – Remove & Replace
Multi-Point Inspection,Changed Motor Oil & Replaced Filter, Added 6 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels.
check engine light inspectiomn
Victor g. gave our service a 5 star review on 11/22/2023
2015 Toyota 4Runner
Mileage
74,681
Service Date
11/15/2023
Services Performed
Multi-Point Inspection,Changed Motor Oil & Replaced Filter, Added 7 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels.
Remove tire Prep and patch affected areas. Re install tire
Chloe L. gave our service a 5 star review on 11/16/2023
2004 Honda Pilot
Mileage
14,171
Service Date
9/20/2023
Services Performed
scam print reset
Multi-Point Inspection,Changed Motor Oil & Replaced Filter, Added 6 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels.
Remove battery terminals Clean battery terminal with anti- corrosion fluid Re attached terminals
katelyn A. gave our service a 5 star review on 9/21/2023
2015 Mercedes-Benz ML350
Mileage
43,494
Service Date
9/15/2023
Services Performed
Inspect unit and verify intoxalock unit works properly ( non start with out blowing). Get millage from the vehicle. Remove hand held unit and start recalibration on station. Install hand held unit to the vehicle and verify unit works accordingly.
Sergion C. gave our service a 5 star review on 9/17/2023
2017 Toyota Camry
Mileage
81,334
Service Date
8/17/2023
Services Performed
Multi-Point Inspection,Changed Motor Oil & Replaced Filter, Added 5 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels.
SPARK PLUGS – Remove & Replace – Gas,In-Line4
Jaqueline M. gave our service a 5 star review on 8/23/2023
2019 Ford Ranger
Mileage
36,196
Service Date
8/4/2023
Services Performed
P0330 Knock/ combustion vibration Sensor B Circuit. Damaged harness. Sensors recommended.
ENGINE KNOCK SENSOR – Remove & Replace – One or Both – [Includes: R&I Intake Manifold. Includes: R&I Fuel Rails.] – [Includes: Component test.]
This vehicle's owner gave our service a 5 star review on 8/4/2023
2007 Lexus RX 350
Mileage
100,260
Service Date
7/26/2023
Services Performed
Multi-Point Inspection,Changed Motor Oil & Replaced Filter, Added 5 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels.
Ray M. gave our service a 5 star review on 7/28/2023
2009 Acura MDX
Mileage
166,080
Service Date
7/26/2023
Services Performed
Inspect unit and verify intoxalock unit works properly ( non start with out blowing). Get millage from the vehicle. Remove hand held unit and start recalibration on station. Install hand held unit to the vehicle and verify unit works accordingly.
Barry A. gave our service a 5 star review on 7/27/2023
2019 Honda Accord
Mileage
76,113
Service Date
6/26/2023
Services Performed
Perform road test and rack vehicle. Raise vehicle and remove front wheels. Remove front wheels. Remove calipers from spindle assemblies and remove old brake pads. Remove brake rotors from brake rotors from hub assemblies. Install new rotors onto hub assemblies, clean and lubricate caliper pivot and mounting points, install new brake pads into calipers. Install calipers on spindle and torque calipers bolts to manufactures specifications. Install wheel assemblies torque lug nuts to manufacturers specifications. Road test to verify brake performance and to seat in new pads.
Multi-Point Inspection,Changed Motor Oil & Replaced Filter, Added 5 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels.
Jose M. gave our service a 5 star review on 6/28/2023
2006 Scion xB
Mileage
45,663
Service Date
5/19/2023
Services Performed
STEERING KNUCKLE – Remove & Replace – One Side – [DOES NOT include alignment.]
Remove and replace strut left side
Remove and replace lower control arm left side
Left side
TIE ROD &/OR END – Remove & Replace – Inner,One Side – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. If Camber and/ or Caster are not within Spec and adjustment can not be perform because of special equipment prepare estimate, do advise costumer.Set Front toe. Remove alignment equipment. Road test Vehicle.
Eric D. gave our service a 5 star review on 6/16/2023

CRM Mitchell1

We Service and Repair all CRM Mitchell1 cars