Toyota Archives - JR Automotive

2016 Toyota RAV4
Mileage
60,915
Service Date
4/2/2026
Services Performed
BRAKE SYSTEM – Fluid exchange
Perform road test and rack vehicle. Raise vehicle and remove front wheels. Remove front wheels. Remove calipers from spindle assemblies and remove old brake pads. Remove brake rotors from brake rotors from hub assemblies. Install new rotors onto hub assemblies, clean and lubricate caliper pivot and mounting points, install new brake pads into calipers. Install calipers on spindle and torque calipers bolts to manufactures specifications. Install wheel assemblies torque lug nuts to manufacturers specifications. Road test to verify brake performance and to seat in new pads.
Perform road test and rack vehicle. Raise vehicle and remove Rear wheels. Remove rear wheels. Remove calipers from spindle assemblies and remove old brake pads. Remove brake rotors from brake rotors from hub assemblies. Install new rotors onto hub assemblies, clean and lubricate caliper pivot and mounting points, install new brake pads into calipers. Install calipers on spindle and torque calipers bolts to manufactures specifications. Install wheel assemblies torque lug nuts to manufacturers specifications. Road test to verify brake performance and to seat in new pads.
Gustavo D. gave our service a 5 star review on 4/3/2026
2013 Toyota Prius
Mileage
151,489
Service Date
10/1/2025
Services Performed
Verified customer concern, passenger side low beam does not turn on when lights are on. Performed inspection, Swapped bulbs and verified bulb is good, tech noticed bulb comes on for a few seconds at times when wiring going to bulb socket is moved slightly. Wiring going to socket is not OEM and has been repaired before. Recommend to repair wiring and replace connector.
LOW BEAM HEADLAMP SOCKET – Remove & Replace – Right Side
Performed All DTC scan and found codes for MAF and TPMS low battery. Advised Customer that one or several TPMS batteries are dead and should be replaced to return TPM system back to working order. Visual inspection found intake tubing cracked and resonator broken. Further diagnostic recommended for stored MAF code.
Celestina P. gave our service a 5 star review on 10/2/2025
2025 Toyota RAV4
Mileage
6,650
Service Date
9/30/2025
Services Performed
Replace Engine Oil and Oil Filter Perform Battery Load Test and Inspect Condition Install Windshield Washer Solvent Check and Adjust Tire Pressure Lube Chassis Where Applicable Inspect All Exterior Lights Inspect Tires For Wear Inspect Drive Belt Inspect Brake Components & Linings For Wear/Damage Check All Serviceable Fluid Levels & Condition Perform Multi-Point Inspection
Remove tire Prep and patch affected areas. Re install tire
Dan p. gave our service a 5 star review on 9/30/2025
2009 Toyota Prius
Mileage
100,997
Service Date
9/5/2025
Services Performed
P1116- Coolant Temperature sensor circuit stuck for coolant heat storage system *P1121- Throttle Pedal Position sensor performance problem coolant flow control valve position sensor circuit stuck off.
High voltage check valve pump – Remove & Replace –
Smog Certification
Chaska B. gave our service a 5 star review on 9/5/2025
2015 Toyota Prius
Mileage
135,819
Service Date
6/24/2025
Services Performed
Inspect unit and verify intoxalock unit works properly ( non start with out blowing). Get millage from the vehicle. Remove hand held unit and start recalibration on station. Install hand held unit to the vehicle and verify unit works accordingly.
Julie F. gave our service a 5 star review on 6/25/2025
2004 Toyota Sequoia
Mileage
202,797
Service Date
6/11/2025
Services Performed
Verified customer concern, brake lights stay illuminated regardless of pedal position and ignition position. vehicle can be completely shut off and key out of vehicle and doors locked and brake lights will stay on, Perform inspection. Tech inspected components and found brake light circuit active and on before fuse. Performed test of brake light switch and verified switch is functioning normal at this time and is able to shut off and turn on lights, although when testing switch tech noticed brake pedal switch pad missing. Installed new brake pedal switch pad and no adjustment to brake light switch was needed. Brake lights now functioning normally.
John C. gave our service a 5 star review on 6/11/2025
2010 Toyota FJ Cruiser
Mileage
88,103
Service Date
3/5/2025
Services Performed
INSPECTION – CHECK ENGINE LIGHT ON Customer states check engine light is on and vehicle idles rough, Inspect and Report.
SPARK PLUGS – Remove & Replace
PCV VALVE – Remove & Replace
Bill M. gave our service a 5 star review on 3/6/2025
2014 Toyota Sienna
Mileage
111,913
Service Date
11/25/2024
Services Performed
According to costumer ther is noise concern, winter pack and gas door/sliding door issue. Inspect and report.
Perform road test and rack vehicle. Raise vehicle and remove front wheels. Remove front wheels. Remove calipers from spindle assemblies and remove old brake pads. Remove brake rotors from brake rotors from hub assemblies. Install new rotors onto hub assemblies, clean and lubricate caliper pivot and mounting points, install new brake pads into calipers. Install calipers on spindle and torque calipers bolts to manufactures specifications. Install wheel assemblies torque lug nuts to manufacturers specifications. Road test to verify brake performance and to seat in new pads.
Perform road test and rack vehicle. Raise vehicle and remove Rear wheels. Remove rear wheels. Remove calipers from spindle assemblies and remove old brake pads. Remove brake rotors from brake rotors from hub assemblies. Install new rotors onto hub assemblies, clean and lubricate caliper pivot and mounting points, install new brake pads into calipers. Install calipers on spindle and torque calipers bolts to manufactures specifications. Install wheel assemblies torque lug nuts to manufacturers specifications. Road test to verify brake performance and to seat in new pads.
Install fuel door
Paint to match Fuel Door
Mount and balance tire
AXLE SHAFT – Remove & Replace – FWD Right Side – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, this operation consists of removal and installation, dissassembly and reassembly of the Axle Shaft Assembly and replacement of the A
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. If Camber and/ or Caster are not within Spec and adjustment can not be perform because of special equipment prepare estimate, do advise costumer.Set Front toe. Remove alignment equipment. Road test Vehicle.
Carolyn D. gave our service a 5 star review on 11/26/2024
2011 Toyota Venza
Mileage
208,154
Service Date
10/22/2024
Services Performed
ALTERNATOR ASSEMBLY – Remove & Replace – In-Line4 – [Includes: Test.]
Raymond C. gave our service a 5 star review on 10/23/2024
2013 Toyota Corolla
Mileage
64,668
Service Date
8/26/2024
Services Performed
Replace Engine Oil and Oil Filter Perform Battery Load Test and Inspect Condition Install Windshield Washer Solvent Check and Adjust Tire Pressure Lube Chassis Where Applicable Inspect All Exterior Lights Inspect Tires For Wear Inspect Drive Belt Inspect Brake Components & Linings For Wear/Damage Check All Serviceable Fluid Levels & Condition Perform Multi-Point Inspection
Performed Tire Rotation
Christina C. gave our service a 5 star review on 8/30/2024

Toyota

We Service and Repair all Toyota cars